You can move around with your keyboard
plus
minus
left
right
Drop pin on the map to start a new report
space
Press space again to adjust the location
space
Start new report here Reposition report here
Back to all reports

Street lights are not working in Stanley Road West this week commencing 27/10/25

Reported via desktop in the Street light fault category anonymously at 18:31, Thu 30 October 2025

Sent to Bath and North East Somerset Council less than a minute later. Council ref: 8358170.

Street lights not working. They were repaired after a previous outage in August but are now not working again.

Updates

  • We can confirm that there is a power supply issue with these lights and the fault has been reported to National Grid. We await their attendance and feedback and shall add further information here when known.

    State changed to: In progress

    Posted by Bath and North East Somerset Council at 10:28, Tue 4 November 2025

  • Further to above, we confirm we have chased our contractors to the attendance to these works for light 002. We shall add further information here when known and are sorry for the delay.

    Light number 3 is awaiting attendance by National grid as there is a power supply issue.

    We shall add further information here when known.

    Posted by Bath and North East Somerset Council at 09:43, Tue 25 November 2025

  • Further to above we understand that National Grid works to light number 3 are now complete so that light should be working as normal.

    Posted by Bath and North East Somerset Council at 12:09, Tue 25 November 2025

  • The street light is still not working, and contrary to above, it was never fixed.

    Posted anonymously at 23:29, Sat 29 November 2025

  • We understand that works are now complete and the lights should be working as normal. This report is now closed but if there are further issues then please log a new report.

    State changed to: Fixed

    Posted by Bath and North East Somerset Council at 14:52, Thu 18 December 2025

This report is now closed to updates from the public. You can make a new report in the same location.